Manual Mass Entry

The following information applies to the : CAL3K-AP , CAL3K-A , CAL3K-U, CAL3K-F.


The Mass is entered in two ways:

  • Through a keyboard entry
  • Through a balance connection (See: BALANCE MASS)

KEYBOARD MASS ENTRY

CAL3K Keyboard Commands - Escape | DDS Calorimeters Exit, Clear command entry
CAL3K Keyboard Commands - M Key | DDS CalorimetersCAL3K Keyboard Commands - A Key | DDS CalorimetersCAL3K Keyboard Commands - S Key | DDS Calorimeters Start of command, CAL3K completes the line as MASS
CAL3K Keyboard Commands - Enter Key | DDS Calorimeters Accept Command
CAL3K Keyboard Commands - 0 Key | DDS CalorimetersCAL3K Keyboard Commands - Fullstop Key | DDS CalorimetersCAL3K Keyboard Commands - 5 Key | DDS Calorimeters Enter Value
CAL3K Keyboard Commands - Enter Key | DDS Calorimeters Accept Value, show data
OR
CAL3K Keyboard Commands - Escape Key | DDS Calorimeters Exit, Clear command entry
CAL3K Keyboard Commands - F1 Key | DDS Calorimeters Start of command, Mass
CAL3K Keyboard Commands - Enter Key | DDS Calorimeters Accept Command
CAL3K Keyboard Commands - 0 Key | DDS CalorimetersCAL3K Keyboard Commands - Fullstop Key | DDS CalorimetersCAL3K Keyboard Commands - 5 Key | DDS Calorimeters Enter Value
CAL3K Keyboard Commands - Enter Key | DDS Calorimeters Accept Value, show data

After the last entry the mass appears in the top line. This indicates it is locked.

A locked mass can’t be changed, and if a change is required, then the mass must be unlocked with the following procedure:

CAL3K Keyboard Commands - Enter Key | DDS Calorimeters Exit, Clear command entry
CAL3K Keyboard Commands - M Key | DDS CalorimetersCAL3K Keyboard Commands - A Key | DDS CalorimetersCAL3K Keyboard Commands - S Key | DDS Calorimeters Type full command MASS
CAL3K Keyboard Commands - Enter Key | DDS Calorimeters Accept Command
CAL3K Keyboard Commands - Delete Key | DDS Calorimeters Delete, Abort Command

Note: That the Function Key F1 can’t be used for unlocking.

MASS LIMITS

The CAL3K performs a mass limit check every time a new mass is entered. The Minimum and Maximum mass limits can be set on a PC.

The default limits are:

Minimum Mass: 0.2 gr

Maximum Mass: 1.0 gr

Leave a Reply

Your email address will not be published. Required fields are marked *