Removing and Replacing the Peltier Element on the CAL2K Water Cooler

CAL2K WATER COOLER

REMOVAL AND REPLACEMENT OF THE PELTIER ELEMENT


STEP 1

Remove the 2 screws that hold the two parts of the pads together.


STEP 2

Separate the two parts.

Remove the element and take note of the polarity.


STEP 3

Clean the surfaces of the two parts.


REPLACEMENT OF THE PELTIER ELEMENT

STEP 1

Smear each surface of the element with heat sink compound.


STEP 2

Place the element on one surface ensuring correct polarity.


STEP 3

Place the two parts together, making sure they are the correct way around, as shown below.

Place the screws in the holes and tighten each individually, a small amount at a time.


STEP 4

Refit the pad the same way as it was removed.


STEP 5

Ensure that the internal water pipes do not get any twists in them.

STEP 6

Check for water leaks.

Leave a Reply

Your email address will not be published. Required fields are marked *